This document will show how to deploy a software release on a SlapOS Webrunner. The process can be used for any software available on the SlapOS repository. Note, that the Webrunner is behaves like a SlapProxy (see SlapOS architecture) in that it contains a "mini SlapOS Master" that can provide a single software. Instantiating a Webrunner thus means, creating a smaller encapsulated system for then deploying another software inside. This is a useful approach for developing or hosting simple software releases.
This section will show how to access a webrunner and deploy a software. The screenshots show deployment of the helloworld software release, also used to explain how to extend a software release.
Locate the connection parameter on your webrunner service. You can access the webrunner using the url and logging in with init-user and init-password.
On the Webrunner landing page, select Open Software Release
Locate the Software directory which contains a list of all software releases available on the webrunner. The list is based on the official SlapOS software repository.
Select the Helloworld Software Release, then click Open Software.
Click Save unless modification of the software release is required before deploying the default version. Then click the green arrow to start build and instantiation.
Once saved the deployment of the software will begin. Deployment can take anywhere from a few minutes (simple software, already compiled) to several hours. The log panel will inform of any errors or warnings encountered during deployment.
The top indicator Building State will show the result of (re-)building the software release. If it fails, errors are likley in
software.cfg. The bottom indicator shows the Running State which indicates whether an instance could successfully be deployed from the software release. Errors in this part are likley to be found in
Once both indicators switch to green, the software is deployed and ready to use.
Click on Services in the subheader to open the list of running services. The services defined in the
software.cfg file should be running.
The connection parameters tab displays the parameters defined in the